Door Hinge Mount w/ 2 Gallon Diesel RotopaX

$268.99

Available on backorder

SKU: D4WD057-2G-DLX-1 Categories: ,

Description

Capacity
Each single pack holds 2 gallons

Dimensions
17 3/4 L x 13 1/4 W x 3 H

Yellow Diesel container, Spout included, Made in the USA

Roto-molded container that is durable with thicker walls and stronger construction make it leak-proof along with a sure seal gasket to guarantee your spout wont leak or vibrate loose. Rotopax are the only rotationally molded EPA and CARB compliant containers available for sale in the United States. This is thanks to a patented three layer Roto-Molding process, along with specialty formulated plastic barrier material to meet the governments new extremely low permeability requirements.

PLEASE ALWAYS REMEMBER TO VENT THE FUEL PACK ONCE PER DAY IF THE ELEVATION OR TEMPERATURE CHANGES SIGNIFICANTLY.


This mount product is produced by DIXIE 4 WHEEL DRIVE and is NOT a RotopaX branded product.

Use this mounting Kit to adapt ONE RotopaX branded “Pax Mount” to hold a RotopaX branded container on any driver or passenger door of a JK or JKU Jeep Wrangler. *Kit can be added to front or rear doors on a 2007-2017 JK. Pax Mount and RotopaX Container sold separately.

See images for examples of mounting locations.

Pax Mount and RotopaX Container sold separately. 


Warning: If using this mount with containers on the rear passenger doors, care must be taken when opening and/or closing the front doors with the rear passenger doors in the full open position.

Installation Instructions:

Step 1: With Door in the full closed position, remove the two factory bolts holding the top hinge to the door. (Retain factory bolts)

Step 2: Place one “Roto Base hinge mount” over factory hinge plate. Replace and tighten the factory both bolts to factory specs. (See image #1)

Step 3: Repeat step 1 & 2 with lower hinge.

Step 4: Attach the “Pax” mount (Sold Separately) to the Roto Mount Plate with the 2 supplied 5/16” x 3/4” bolts and 2 5/16” flat washers. *(DO NOT use the bolts supplied with the “Pax” mount.)

Step 5: Fasten the Roto Mount Plate to the two Roto Base hinge mounts using the 4 supplied 5/16“ x 1/2” bolts and 4 of the 5/16” flat washers. (See image #2)

Step 6: Mount Storage containers as instructed by manufacturer.

Package Contents:

– 1x Roto Mount Plate

– 2x Roto Base Hinge Mount

– 4x 5/16″ X 1/2″ SS Button Bolts – 2x 5/16″ X 3/4″ SS Button Bolts – 6x 5/16 SS Flat Washers

– Dixie Sticker

Additional information

Dimensions 16 × 15 × 4.5 in