RotopaX Door Mount

This product is produced by DIXIE 4 WHEEL DRIVE and is NOT a RotopaX branded product.

Use this mounting Kit to adapt ONE RotopaX branded “Pax Mount” to hold a RotopaX branded container on any driver or passenger door of a JK or JKU Jeep Wrangler.

See images for examples of mounting locations.

Pax Mount and RotopaX Container sold separately. 

Installation Instructions:

1. With Door in the full closed position, remove the two factory bolts holding the top hinge to the door. (Retain factory bolts)
2. Place one “Roto Base hinge mount” over factory hinge plate. Replace and tighten the factory both bolts to factory specs. (See image #1)
3. Repeat step 1 & 2 with lower hinge.
4. Attach the “Pax” mount (Sold Separately) to the Roto Mount Plate with the 2 supplied 5/16” x 3/4” bolts and 2 5/16” flat washers. (DO NOT use the bolts supplied with the “Pax” mount.)
5. Fasten the Roto Mount Plate to the two Roto Base hinge mounts using the 4 supplied 5/16“ x 1/2” bolts and 4 of the 5/16” flat washers. (See image #2)
6. Mount Storage containers as instructed by manufacturer.

Warning: If using this mount with containers on the rear passenger doors, care must be taken when opening and/or closing the front doors with the rear passenger doors in the full open position.